KPAQ Industries LLC

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was loading black liquor into a tanker truck using a swivel arm. The arm caught and pinched his right middle finger as it moved, resulting in a partial amputation to the first knuckle.

An employee was visually inspecting the drive line for a conveyor. There was an explosion in the conveyor, and the employee suffered second- and third-degree burns to both forearms.

An employee was driving forklift with a load when the forklift hit a guardrail and the employee fell to the ground, resulting in a broken elbow, broken shoulder, and lacerations.

An employee was putting a chain back on a sprocket. The gearbox and sprocket contained two drive chains connected to the lowerator (vertical conveyor) and counterweight assembly. The employee received an alarm indicating that one of the chains had gone slack. While the employee was putting the chain back on the drive sprocket with tongue and groove pliers, the weight of the chain and counterweight fell back in place on the sprocket, pulling the employee's left hand into a pinch point. The employee's ring fingertip was amputated up to the fingernail.

While troubleshooting equipment, an employee tripped on the turntable of the conveyor system and fell to the floor, fracturing their right femur.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.