105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Cyclone Drilling, Inc.

Contact with objects and equipment, unspecified · Amputations

Federal OSHA recorded a severe workplace injury at Cyclone Drilling, Inc., McLean County near Parshall, ROSEGLEN, NORTH DAKOTA 58775 on — Amputations, affecting the nonclassifiable.

An employee suffered an amputation injury while rigging up a top drive at or near Parshall, North Dakota.

Amputation Nonclassifiable Oil drilling rigs and machinery

Cyclone Drilling Inc.

An employee was pulling drill line from the drill spool while the top drive was not set on the docking pins. The deadman was unexpectedly released which caused the top drive to fall to the drill floor from a height of 30 feet. This caused the drill line that was being pulled out and laid on the ground to retract and strike an employee. The employee suffered fractures to his legs and neck.

Cyclone Drilling Inc.

An employee was standing in front of a heater, watching a casing being floated into a hole to seal it. A ball valve failed and burst apart, fracturing the employee's cheekbone and lacerating his cheek.

CYCLONE DRILLING, INC

An employee was moving a well head blow out preventer (BOP) stack and the chains slipped, amputating approximately 3/8" of the employee's left index finger.

View Cyclone Drilling, Inc.'s full OSHA safety record →

NorAm Drilling Company

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Stalworth Underground LLC

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

National Park Service U.S. Department of the Interior

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

HT Energy LLC

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

TKM BENGARD FARMS, LLC

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

Hall Drilling, LLC

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

C. Miller Drilling Inc

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

Amercian Well Service Llp

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

Axis Energy Services

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

ROBINSON DRILLING OF TEXAS, LTD

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

Midwest Motor Express, Inc.

An employee fell from a dock to ground level (less than 4 feet) and broke their tibia/knee.

J-Mar Enterprises

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

J.R. Simplot Co

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

Dickinson Ready Mix Co.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

American Industrial Services

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.