Pedestrian struck by vehicle in nonroadway area, unspecified · Fractures and other injuries, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Gilman Building Products, LLC. , 1509 South Byron Butler Parkway, PERRY, FLORIDA 32348
on — Fractures and other injuries, n.e.c., affecting the multiple body parts, n.e.c..
Final narrative
An employee was walking and was run over by the forklift. The employee suffered broken ribs, a collapsed left lung, broken vertebra, and a toe amputation.
AmputationMultiple body parts, n.e.c.Forklift, order picker, platform truck-powered
More severe injuries at Gilman Building Products, LLC.
An employee was replacing a broken pin at the sorter bay. After removing the pin, the employee used a carter pin to energize the valve. The cylinder rod extended and he used his left index finger to check the alignment of the clevis and Pad-I. The carter pin slipped, causing the valve to de-energize and the cylinder to retract and amputate his left index fingertip.
An employee was sorting wooden boards on a finish line when a board weighing approximately 30 pounds fell on the employee's head. The employee suffered partial paralysis of the hands and feet and was hospitalized. The employee was wearing a hard hat at the time of the incident.
An employee was helping a chip saw operator clear the chip saw when he placed his right hand on the cutting head machine. The machine then amputated his right index fingertip without bone loss.
An employee was on the roof to repair a leak when he stepped on and fell 24 feet through the sky light to the ground resulting in a broken hip. He was admitted to the hospital.
An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.
An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.
An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.
An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.