Struck by falling part of powered vehicle still attached · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Chart Industries, 3515 Dawson Rd., TULSA, OKLAHOMA 74115
on — Bruises, contusions, affecting the hand(s) and arm(s), n.e.c..
Final narrative
An employee was helping to place a motor on the bed of a truck using a forklift. He reached under the forks to unhook a chain when the forks came down crushing his hand and forearm. No bones were broken, but he suffered severe bruising and a compression injury. The employee's arm was lanced from the wrist to the elbow to relieve internal pressure.
HospitalizedHand(s) and arm(s), n.e.c.Forklift, order picker, platform truck-powered
An employee was standing on part of an extension ladder when the ladder slipped out from under him, causing him to fall 4 feet to the ground. The employee sustained a left hip fracture.
An employee was removing a stuck 100-pound fiberglass fan blade from a mold. A wedge between the blade and the mold came out, and the blade dropped down and lacerated his right ring fingertip. He was hospitalized.
An employee was fixing a mechanical casket lift in a vehicle when the lift came down on their left-hand fingers, resulting in amputation of two fingers.
An employee was helping to remove the clamp attachment paddles from a forklift so they could then repair a hydraulic leak. The clamp fell and pinned the employee's right ring finger against the mast. The employee's finger was partially amputated.
An employee was on a truck attempting to stow an aluminum extension ladder onto the truck's conveyor boom system. As the conveyor mast was lowered, the boom control area came down on top of the employee's left foot, resulting in two toe fractures.
An employee was standing on the elevated forks of a forklift to install the fork chain anchor nut. The employee slipped and as he went to catch himself, he accidentally engaged the up-down control for the forks. This caused the forks to fall onto his foot. The employee's right foot was crushed and all of his right toes were amputated.
An employee was working on a scissor lift when a portion of the unit came down and struck their head at the lift base. The employee sustained a head laceration and a skull fracture.
More severe injuries in this industry (NAICS 332410)
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.
An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.
An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.