Indirect exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at U-TEC CONSTRUCTION , INC, 5701 Spalding Drive, NORCROSS, GEORGIA 30092
on — Electrical burns, unspecified, affecting the nonclassifiable.
Final narrative
An employee was installing light posts when the derrick truck swung the light post and contacted the power line behind them. The trailer holding the post became energized, and the employee received severe electrical burns.
HospitalizedNonclassifiableLamp posts, street lights
An employee was in a bucket truck upgrading street pole lights when their arm contacted an energized power line. An arc flash occurred and the employee sustained electrical burns.
A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.
On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.
An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.
An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.
An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.
More severe injuries in this industry (NAICS 517110)
An employee was descending a ladder that was on a strand when the ladder shifted, causing the employee to jump off and fall about 5.5 feet to the ground. The employee sustained a fractured right ankle.
An employee was removing 2,500-foot reels of 1 cable-in-conduit (CIC) weighing ~1,022 lbs. from the back of an enclosed delivery truck. The employee was manually rolling a reel off the truck when another reel shifted and rolled forward, crushing his right hand between the two reels. The employee's right ring finger was partially amputated without loss of bone.
An employee was on an extension ladder working to replace a service line to a customer's home. The existing service line broke, causing him to fall off the ladder. He was hospitalized with a dislocated elbow and fractures in his left wrist requiring surgery.
An employee stepped on a traffic cone while walking to a truck. The employee slipped and fell, suffered a fractured and possibly dislocated ankle, and was hospitalized, requiring surgery.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.