Carpenter Latrobe Specialty Metals

An employee was operating a shear on the continuous rolling mill. While a steel bar was being cut on the shear, it pivoted and struck the employee, fracturing their left arm.

A maintenance technician was working on the #2 GB Dust Collector/Grinder to change the belt on the motor. The employee's right pinky finger got caught between the belt and the fly wheel, amputating part of his finger.

An employee suffered a hernia/hematoma while adding Fluorspar onto the ladle of the electric arc furnace.

An employee was walking down the hallway when they tripped and fell to the floor, fracturing their right wrist.

An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.

An employee was carrying furniture backward during a delivery when he tripped and broke his right ankle.

An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.

An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.

An employee was removing a roll (tooling) from a machine when their left little finger was pinched between the roll and the machine, resulting in a partial amputation.

An employee was rolling a piece of steel in the belt of a shape roller machine when his finger was pinched between two pieces of steel. His right ring and middle fingers were amputated.

An employee was cutting a length of steel coil when he noticed the steel might have cross-break defects. He used his gloved hand to feel for and clean the defected spots when his glove got caught in the measuring wheel, which rolls along the top of the steel to ensure accurate cuts. The employee's arm was pulled down into the machine until his body was stopped by a support bar that goes across the machine. The employee's arm was fractured at the elbow and required hospitalization.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.