Struck by falling part of powered vehicle still attached · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Scott Companies, 11202 S. 150th Street, OMAHA, NEBRASKA 68138
on — Fractures, affecting the lower leg(s).
Final narrative
An employee was working on a front-end loader, taking the lift cylinder from the hood. The employee had the hood at a 90-degree angle. The hood moved and struck the employee on the leg, fracturing both bones in the lower left leg.
HospitalizedLower leg(s)Bucket, front-end, end, and pay loaders
An employee was fixing a mechanical casket lift in a vehicle when the lift came down on their left-hand fingers, resulting in amputation of two fingers.
An employee was helping to remove the clamp attachment paddles from a forklift so they could then repair a hydraulic leak. The clamp fell and pinned the employee's right ring finger against the mast. The employee's finger was partially amputated.
An employee was on a truck attempting to stow an aluminum extension ladder onto the truck's conveyor boom system. As the conveyor mast was lowered, the boom control area came down on top of the employee's left foot, resulting in two toe fractures.
An employee was standing on the elevated forks of a forklift to install the fork chain anchor nut. The employee slipped and as he went to catch himself, he accidentally engaged the up-down control for the forks. This caused the forks to fall onto his foot. The employee's right foot was crushed and all of his right toes were amputated.
An employee was working on a scissor lift when a portion of the unit came down and struck their head at the lift base. The employee sustained a head laceration and a skull fracture.
More severe injuries in this industry (NAICS 532412)
An excavator bucket was being removed. An employee was pulling a snap ring to remove a pin and lost his grip. The high-tension snap ring recoiled and his left middle fingertip was amputated by the snap ring.
An employee was walking between service bays. He came into contact with a trailer hitch, which was sticking out of the back of a lawn mower, and fell to the concrete floor. He landed on his right side and suffered a broken hip.
An employee was taking a scissor lift off a flatbed trailer. While using the remote operator controls and walking alongside the lift, the wheel of the lift turned in the wrong direction, causing it to strike the employee and roll over his left ankle. The employee was hospitalized with two broken bones in his ankle.
An employee was working on an excavator's tracks. He was swinging a sledgehammer to finish pushing a metal tractor pin into the track links. A hammer-blow caused a piece of the pin to fly off, ricochet, and embed itself in his buttock. He was hospitalized, requiring surgery.
An employee was picking up crane pads to put onto their trailer. Their finger got pinched between pads, resulting in an amputation involving the loss of skin.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.