Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Wal-Mart Stores, Inc, 3010 Larue St., GARDEN CITY, KANSAS 67846
on — Electrical burns, unspecified, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was driving a forklift when the load contacted the overhead lighting, dislodging it from the overhead trusses. The employee then attempted to secure the lighting fixture to prevent it from falling. He used a scissor lift to access the light and was in the process of securing it when he touched the fixture, receiving an electric shock and burns to the left ring finger, as well as left arm numbness.
On February 20, 2025, at approximately 5:45 p.m., an employee was stocking bananas when he tripped and fell to the ground, injuring his right hamstring. He was hospitalized with a hematoma and a torn ligament.
On October 27, 2023, the injured employee was moving material from the aisles to the staging area when another forklift entered the aisle. The injured employee jumped from his forklift, injuring his lower leg on a pallet being transported on the other forklift.
An employee was checking receipts when they were punched by a customer, fell and struck their head on the ground. They sustained a brain bleed and concussion.
An employee was operating a forklift outside in the garden center. The forklift went between two bollards and his left foot was caught between a bollard and the forklift. The employee sustained a deep laceration to the side of his foot and the little toe was medically amputated.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 45399)
An employee was unloading a trailer when her shoelaces were caught in a conveyor wheel, causing her to trip and fall on her right knee. The knee was fractured and required surgery.
An employee was walking down the aisle when she slipped on the wet floor and twisted her ankle. Her ankle began to swell immediately and was broken in two places. She also fell and hit her head on the floor.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.