Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Janesville Acoustics, 221 Fabritek Drive, COLUMBUS, MISSISSIPPI 39702
on — Amputations, affecting the hand(s), unspecified.
Final narrative
An employee was operating a lapper machine when its vacuum hose clogged. He turned the machine off, opened the doors, and attempted to unclog it. His hand got caught in the machine and was crushed, resulting in a hand amputation.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 325220)
A temporary employee cut back-wrapped material on an extrusion line. His left hand was caught in the material as he tried to clear it. As the material continued to rotate, the employee's left ring finger was severed, resulting in a partial amputation.
An employee was using a plastic pipe to clear a jam in the shredding equipment. The pipe got stuck in the shredder and went into a vertical position, crushing the employee's left ring finger between the pipe and the top of the shredder shroud. The employee sustained a fingertip amputation.
An employee was operating a stand-up forklift to move a pallet of product that was sitting on the floor in an aisle of the finishing warehouse next to metal racking. The forklift cab went under the middle shelf and his torso became caught between the metal shelf (at his back) and the forklift steering control stick (at his front). He was hospitalized with possible fractured ribs.
An employee was starting to collect edge trim when their right middle and ring fingers came into contact with a shear slitter blade. Half of the ring finger was nearly amputated, and half of the middle finger was amputated.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.