TECUMSEH, KANSAS—
Futamura USA, Inc.
Collision with stationary object, nonroadway · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Futamura USA, Inc., 6000 SE 2nd St, TECUMSEH, KANSAS 66542 on — Fractures , affecting the Rib(s), oblique area.
Final narrative
An employee was operating a stand-up forklift to move a pallet of product that was sitting on the floor in an aisle of the finishing warehouse next to metal racking. The forklift cab went under the middle shelf and his torso became caught between the metal shelf (at his back) and the forklift steering control stick (at his front). He was hospitalized with possible fractured ribs.
More severe injuries at Futamura USA, Inc.
TECUMSEH, KANSAS—
Futamura USA, Inc.
An employee was kneeling on the padded work platform of a casting machine, reaching to pull slack out of a film web being re-threaded through the machine. He lost his balance and slipped, and his right hand, wrist, and forearm were burned in the 90 C hot water bath.
TECUMSEH, KANSAS—
Futamura USA, Inc.
An employee had climbed onto a machine platform and gotten down on his hands and knees to look for the cause of a defect in film that was running on a slitting machine. He slipped and his left hand went into the machine, where it was caught between a roller and a bar. He suffered broken tendons in the hand and wrist.
TECUMSEH, KANSAS—
Futamura USA, Inc.
At approximately 0900, an employee was trying to move a pulp roll back into position on a pulp feed rack. The pulp roll slid off the rack onto the floor and caught the employee's right arm against the rack. The employee was hospitalized with a broken arm that required surgery.
TECUMSEH, KANSAS—
Futamura USA, Inc.
An employee was taking lab waste to a special waste dumpster. The employee fell through grating adjacent to the special waste dumpster approximately 4 feet to the concrete floor and sustained broken bones in both feet.
TECUMSEH, KANSAS—
Futamura USA, Inc.
An employee working as a finishing operator was using sand paper to clean a spindle roll on a slitter machine. The employee's arm was caught in the spinning rollers. The employee sustained a compound fracture to the right arm requiring hospitalization and surgery.
View Futamura USA, Inc.'s full OSHA safety record →
Similar incidents · Same event type
CANTON, OHIO—
Abbott Electric Inc
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
DENVER, COLORADO—
FLATIRON CONSTRUCTION CORP.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
KUNA, IDAHO—
Cupertino Electric, Inc.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
NORTHAMPTON, MASSACHUSETTS—
Warner Brothers, LLC
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
OCALA, FLORIDA—
Signature Brands
An employee was operating a stand-up forklift. The forklift drove into a rack in a warehouse, and the employee's right hand was caught between the rack and an upright supporting the forklift's overhead guard. The employee suffered a fracture and laceration to the hand, just below the little finger.
More severe injuries in this industry (NAICS 325220)
PENDERGRASS, GEORGIA—
AMERICAN SYNTHETIC FIBER, LLC
An employee opened a screen changer when pressurized steam and resin blew out from the changer, resulting in a fourth-degree burn to their left arm.
KINGMAN, KANSAS—
Great Lakes Polymer Technologies LLC
A temporary employee cut back-wrapped material on an extrusion line. His left hand was caught in the material as he tried to clear it. As the material continued to rotate, the employee's left ring finger was severed, resulting in a partial amputation.
WACO, TEXAS—
Applegate Greenfiber Acquisition, LLC 8
An employee was using a plastic pipe to clear a jam in the shredding equipment. The pipe got stuck in the shredder and went into a vertical position, crushing the employee's left ring finger between the pipe and the top of the shredder shroud. The employee sustained a fingertip amputation.
DECATUR, ALABAMA—
3M Company, Inc.
An employee was starting to collect edge trim when their right middle and ring fingers came into contact with a shear slitter blade. Half of the ring finger was nearly amputated, and half of the middle finger was amputated.
DEPEW, NEW YORK—
Sefar Inc.
An employee's thumb tip was amputated in a chain and sprocket.
More severe injuries in KANSAS
WATHENA, KANSAS—
Omya Inc.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
COFFEYVILLE, KANSAS—
John Deere Coffeyville Works
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
HAVEN, KANSAS—
Haven Steel Products Inc
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
MINNEOLA, KANSAS—
Vestas-American Wind Tech
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
MEADE, KANSAS—
Alliance Ag and Grain LLC
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.