H. KRAMER & COMPANY

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was monitoring a conveyor at the operator station. A piece of metal was fed to a conveyor system and it struck another piece of metal, causing a piece of titanium (1-inch-long and 1/2-inch-wide) to break off and strike the employee in their upper chest below the clavicle. The employee was hospitalized and the embedded piece of metal was surgically removed.

An employee was working by the slag side of a reverb in the furnace department. They returned home after the end of their shift and began feeling muscle cramps, resulting in hospitalization due to dehydration.

An employee had been working in the refinery area of the facility. He then began to feel dizzy and suffered other heat illness symptoms. He was hospitalized for possible heat stress.

On May 14, 2025, an employee was sitting cross-legged and removing a pneumatic rail car vibrator from its bracket to empty the next pocket in the rail car. When the employee went to set the vibrator down, he placed it on a hammer that was sitting in front of him and the vibrator teetered to the side, catching his little finger. The employee sustained an amputated fingertip at the first knuckle.

An employee was opening a railcar compartment using a wrench when the tool broke and the employee slipped and fell to the same level. The employee sustained a fractured lower right leg.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.