Ricker Hill Farm

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was inspecting materials in a warehouse area. While she was in a main aisle, a forklift backed into her foot. She suffered a possible fracture to the foot and was hospitalized.

An employee was using a table saw to cut wood when their fingers came in contact with the blade. The employee sustained amputations of one or more digits.

An employee was standing on a step ladder picking apples from a dwarf apple tree while holding a bag weighing approximately 35 pounds. The employee slipped and fell approximately 4.5 feet to the ground, resulting in a fracture to the lower left leg. The employee was hospitalized.

An employee was working from a scissor lift to paint piping. The employee finished painting, lowered the lift, unlatched the chain on the back, and was standing on the top step of the ladder that is used to access the work platform. The lift raised approximately 6 feet into the air and the employee fell onto the concrete floor below. The employee sustained a concussion and a neck fracture requiring hospitalization.

An employee was tightening the gas cap on a tree trimmer that had been recently turned off but had gas spillage around the cap. The trimmer ignited, burning his hands, face, and chest.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.