R & S Maintenance Services

An employee was pushing a hose out of an exterior door on the second floor of a facility. The hose lifted up the hand rail and the employee fell over it, landing on the ground 12 feet below. The employee suffered a broken right ankle.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

A building engineer was inspecting a generator. As he closed the generator enclosure door, his right ring finger was caught between the door and the door frame. The fingertip was amputated.

An employee was planing lumber on a jointer. While he was feeding the workpiece into the jointer, it hung up and he lost his grip on it. His gloved hand came into contact with the point of operation, and his left little finger was partially amputated near the first joint.

An employee was on an extension ladder cleaning an outdoor dryer duct when he fell to the concrete ground. The employee sustained two brain bleeds, punctured lungs, fractures to their hip, tibia, face, vertebrae, left wrist, shoulder, and upper arm, as well as an open fracture to the arm.

An employee was in an elevator pit working on the hoisting cables and compensator sheave. He moved the cables back onto the sheave groves. One of the cables spun, twisted out of the grove, grabbed his glove, and pulled his hand into the sheave. The tip of his right thumb was caught under a cable and was amputated approximately at the knuckle just below the nail.

An employee had used cleaning solvent to clean the engine room. The employee turned on a vacuum, which caused an explosion to occur, followed by a fire. The employee was hospitalized with second-degree burns.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.