Alberici Constructors, Inc.

An employee was rigging a piece of metal that weighed 434 pounds. He hooked the clamp to the gantry crane and stood the base plate on its end to check the balance and placement of the clamp. The employee then raised the plate and swung it over to the steel column. The baseplate bumped into the column and the clamp released. The employee's index, middle, and ring fingers were lacerated by holes in the base plate as it slipped against the column and fell to the floor. The index and middle fingertips were amputated.

An employee fell 15 feet from a wet ladder fracturing the L2 vertebra.

An employee dismounted from a crane boom he was reconfiguring and fractured his ankle.

An employee was walking along a trench inspecting the trench box in the excavation when he tripped and fell toward the trench. As the employee was falling head-first into the trench, he attempted to get a hold of the fall protection cable. The cable then looped around his left hand and the employee fell approximately 8 feet into the trench before the fall protection engaged. The employee suffered amputations of his left index, middle, ring, and little fingers.

A ranger was performing back-country patrol duties while hiking. As they were climbing a technical rock patch, a rock handhold broke, causing the employee to fall approximately 15 feet before their belay engaged. The employee contacted a rock, resulting in a fracture to the right ilium as well as a subcutaneous hematoma to the right gluteal region.

Employees were erecting structural steel. The injured employee was sitting on a 12" wide horizontal member and lining up an I-beam brace as it was suspended by an overhead crane. He leaned left to push the end of the brace. The end of the suspended brace swung away from him, causing him to lose balance and fall 8 feet. His personal fall arrest system arrested his fall, but he swung into a piece of duct work during the fall that resulted in a concussion.

On September 12, 2022, an employee was on a metal roof, installing a standing seam and insulation. He lost his balance and fell toward the third floor slab, which was 10 feet from the roof. His fall protection caught him and left him suspended about 2 to 4 feet from the slab. He suffered a brain bleed and a spinal fracture in his lower back. He was hospitalized.

An employee was working from a bucket lift, removing a tree in sections. He lost his balance while pushing on a section and fell. His fall protection caught him and he swung into a tree, suffering an injury that caused head, neck, and leg pain, as well as loss of consciousness while he was at the hospital.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was installing insulation in a wall when she tripped on a hole (12" deep) and fell, hitting her head on the concrete floor. The employee sustained fractures to her leg and wrist, and lacerations to her head. The employee was hospitalized.

An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.

An employee was operating a power drill when it slipped. The drill bit punctured the employee's hand and they were hospitalized.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.