Struck against stationary object or equipment, n.e.c. · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Baker Hughes, 9110 Grogans Mill Rd., THE WOODLANDS, TEXAS 77380
on — Cuts, lacerations, affecting the forearm(s).
Final narrative
An employee was trying to put a bit in a lifting rig for transport via a trolley crane. As he was extending his right arm it made contact with a sharp edge of the bit causing a laceration to the right forearm. The bit weighs approximately 50 pounds is 12 inches in length and 18-24 inches in width.
HospitalizedForearm(s)Machine and appliance parts, n.e.c.
During routine maintenance of the bonnet end cap on a blowout preventer, the cap fell and smashed an employee's right ring finger against another ram bonnet. The finger was amputated.
An employee was positioning an oilfield drill bit when it fell from the connection fixture it was connected onto. The bit fell onto the employee's left ring fingertip and crushed it against the work surface. The fingertip was medically amputated.
An employee was acting as a spotter and guiding a flatbed operator while standing on the rear passenger side of an outrigger leg when he stepped back onto a mobile crane platform and fell approximately 70 inches to the ground. He was hospitalized with an open fracture to the left ankle.
An employee was unnesting tote bags when her grip slipped and the back of her left hand hit a box containing a steel step stool that was adjacent to the tote bags. The employee's hand was fractured.
An employee was cleaning up and putting away equipment when the second toe on her right foot was stubbed on a fixture, resulting in hospitalization and a subsequent amputation of the toe.
An employee was walking when he tripped on a concrete vault lid, jamming his big toe into the tip of his steel toe boots. The employee's big toe was medically amputated.
An employee was cleaning a bathroom. As the employee bent over, the corner of a sink hit the employee's right eyeball, causing an injury that required hospitalization and surgery.
On September 23, 2023, an employee was cleaning near a conveyor when they knelt with their right knee on the floor. Their knee contacted a small piece of glass on the floor, resulting in a laceration that required hospitalization.
More severe injuries in this industry (NAICS 333132)
Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.
An employee was fitting an arbor fixture into a rotor housing to be reworked. The rotor is moved by a hoist. The arbor was being lowered into the rotor housing when the arbor slipped down onto his hand and amputated a portion of his left thumb.
A crew was tripping out of the hole with an electrical submersible pump (ESP) in the process of swapping tubing tong heads to break down the ESP. An employee's left arm was caught and pinched by the tubing tongs. The employee sustained three lacerations and a fracture to the arm.
On May 21, 2025, at approximately 3:40 PM, a machinist was preparing a CNC lathe machine for it's next run. He was closing the machine door to complete the tooling setup when the door crushed his right middle finger. The employee required a surgical amputation to his fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.