Struck by powered vehicle-nontransport, n.e.c. · Fractures and other injuries, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Keystone Steel and Wire, Inc., 7000 S Adams St, PEORIA, ILLINOIS 61641
on — Fractures and other injuries, n.e.c., affecting the foot (feet), unspecified.
Final narrative
On or about April 14, 2016, at approximately 7 AM, a crane operator and an employee were setting up to carry a load to the mill. The crane operator was setting riggers for the crane while the employee was in the area when the crane's outrigger crushed the employee's left foot, fracturing it and possibly amputating toes.
HospitalizedFoot (feet), unspecifiedCranes-other mobile cranes
More severe injuries at Keystone Steel and Wire, Inc.
An employee was attempting to repair the welding machine with a pair of pliers when the pliers became caught and pulled the employee's hand into the machine, partially amputating the left ring finger.
An employee was going to fill a pallet with items from the warehouse. He was reaching for the handle of the pallet jack but unintentionally grabbed the throttle, causing the pallet jack to move and pin him against another pallet jack. The employee sustained a leg fracture.
An employee was loading merchandise onto rolling containers that were on a remote-operated order picker. While reorganizing merchandise to prevent top loading, the employee's wireless control device contacted a container and caused the order picker to move forward. The employee's right ring finger was caught between two containers and was amputated above the first knuckle.
The injured employee was operating an elevator at a construction site. He went from the tenth floor to the eleventh floor with a plumber and a scissor lift in the elevator. The plumber was using a remote to operate the scissor lift. As the scissor lift was exiting the elevator, a pipe that was on the scissor lift struck the injured employee's chest. The employee was hospitalized.
An employee was dismantling the engine from a vehicle. The vehicle slid off the loader and struck the employee, pushing him into his toolbox. The employee sustained a broken jaw.
More severe injuries in this industry (NAICS 331111)
An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.
An employee was loading a steel forming machine with steel to be processed. He went to move a cooling hose out of the way and his left thumb was crushed by the forming roller, resulting in injuries that required surgical amputation.
An employee was advancing a rail to line up for welding with a secondary rail on the weld line when his right middle and ring fingers were caught between the rails. The employee sustained an amputation to the top knuckle of the middle finger and a fracture to the ring finger. The machine was guarded at the time.
An employee was preparing bundles of 24-foot square metal tubing to be loaded onto a truck and cut the safety band for a bundle. While the employee was removing a piece of dunnage from a bundle, they bumped the bundle with their leg. The metal tubing then fell forward and struck the employee, causing a fractured left ankle.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.