Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Franklin Structures, LLC, 10655 Highway 43, RUSSELLVILLE, ALABAMA 35653
on — Amputations, affecting the forearm(s).
Final narrative
An employee was operating a chop saw to cut wood studs when the chop saw activated via the foot pedal, amputating the employee's left mid-forearm.
An employee was preparing to put a camper in a frame. He raised the jig while his hand was resting on the block. When he lowered the jig, his left thumb was caught between the I-beam and the block, resulting in a thumb tip amputation.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321991)
On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.
An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.
An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.
An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.
An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.