Vehicle or machinery fire · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Flogistix LP, 2538 Kentucky Road, PAMPA, TEXAS 79065
on — Second degree heat (thermal) burns, affecting the multiple body parts, n.e.c..
Final narrative
An employee was using a power wash to clean a rebuilt gas compression unit when a flash fire occurred. The employee sustained 2nd degree burns on the hands, face, neck, and ears.
HospitalizedMultiple body parts, n.e.c.Machinery, unspecified
An employee removed the spark plugs and was rotating an engine to evacuate condensate from the cylinders. An unknown source ignited the condensate and natural gas. The employee sustained burns to the back of his hands and upper leg area.
On 23 February 2015, at approximately 1030 hrs at the Flogistix manufacturing site in Pampa, Texas, employee was cutting a metal stud on a chop saw when the material kicked back and crushed the distal phalanx of the index finger (right hand). The employee was taken to Pampa Memorial Hospital where physicians opted to amputate due to the extent of the injury.
An employee removed the spark plugs and was rotating an engine to evacuate condensate from the cylinders. An unknown source ignited the condensate and natural gas. The employee sustained burns to the back of his hands and upper leg area.
An employee was operating a front-end loader when a hydraulic line broke, causing the front-end loader to catch on fire. The employee jumped from the cab to the ground and sustained fractures to the T-6 vertebra and a heel.
An employee was moving two totes of turpentine. Noticing that one of them was leaking, he stopped his forklift and began to look for the leak. The forklift caught fire, and the employee suffered severe burns. He was hospitalized.
An employee was performing maintenance on a machine when part of an adjacent machine caught fire. The employee extinguished the fire and suffered smoke inhalation.
More severe injuries in this industry (NAICS 213112)
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.