Sanico Inc.

An employee was drying and finishing vehicles when a vehicle door closed on their left middle fingertip and amputated it.

An employee was climbing down from a tractor trailer bed when they lost their footing and grabbed onto the roll-up door to stop the fall. The roll-up door then fell onto the employee's hand, resulting in a hand fracture that required surgery.

An employee was attempting to remove a tarp from a flatbed trailer when the trailer handle struck the employee in the chest, resulting in two broken ribs and a punctured lung.

An employee was near a backhoe while the operator was getting a broom. The broom handle struck the lever that actuates the swing of the backhoe bucket. The bucket then struck the injured employee, pinning him to the outrigger. The employee suffered crush injuries to the chest.

The injured employee was being trained on loading trucks in the load out bay. The injured employee and his supervisor climbed the stairs that run parallel to the truck and trailer, walked to the upper platform used for observation and sample taking, and saw that the lid of the grain trailer was closed. The employees began working to open the lid which appeared to be stuck due to cold weather. The injured employee pulled on one of the pivot arms that connect the lid to the main body of the trailer. As the lid began to open, the employee s right hand slipped down on the pivot arm and his index finger was caught between the pivot arm and the base of the pivot arm. The employee s right index finger was fractured and three nerves were severed. The employee was hospitalized.

Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.

An employee was operating a machine used to roll erosion control fabric. Her left hand was caught and crushed in the rollers. She was hospitalized.

An employee was using a pipe grooving machine to groove an 8-inch pipe. His gloved index finger on his left hand was caught between the groover and the pipe, crushing the top part of his finger. The employee's left index finger was partially amputated.

An employee was cutting electrical wires when an arc flash occurred, resulting in third-degree burns to their hand.

An employee was being trained on operating a powered industrial truck (PIT) with a side-saddle stance. The employee was instructed to move the PIT s joystick back and forward to get a feel for it. The PIT went backward through a dock door that was approximately 3 feet off the ground. The PIT ended up on the employee. The employee was hospitalized with an amputation below the left knee, third-degree burns to lower extremities, and multiple fractures to the lower extremities.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.