WILLMAN INDUSTRIES, INC

An employee was preparing an iron casting so the gating and risers could be removed using an abrasive torch. The employee used a piece of metal found on the ground to support the casting and keep it in a position where the risers could be easily accessed. The employee needed to adjust the sling location on the casting. After slacking the chain, the casting shifted, trapping the employee's left middle finger between the casting and the sling chain and resulting in partial amputation of the left middle fingertip.

An employee was using an overhead hoist to lift a core. Their thumb became caught between the core hook and the hoist hook during a lift, resulting in an amputation of the thumb at the first knuckle.

An employee was crossing over a sorting belt and jumped down onto the catwalk next to the belt. The employee sustained a right ankle fracture and dislocation.

On November 7, 2023, at 6:00 PM, an employee was getting off a roof at the end of the work day. He missed a step and then jumped from the ladder to the ground sustaining a fractured ankle.

An employee was on the table of a machine. She went to jump down from the table and fractured her lower leg on the ground. The employee was hospitalized.

An employee was loading a flatbed trailer when a forklift bumped into the trailer. A wheelset began to roll in his direction and the employee jumped off the trailer to avoid it. The wheelset caught him on the leg and he landed on his shoulder on the ground. He sustained a laceration below the left kneecap and a dislocated shoulder.

An employee jumped off the loading dock to assist a package delivery driver who fell. He sustained an ankle fracture that required surgery.

An employee was realigning two halves of a core box on a core-making machine. Pneumatic pressure released, causing the core box to close on the employee's right thumb. The thumb tip was amputated between the nail and the knuckle.

An employee was performing maintenance/electrical work inside a substation, and used a ladder to access the top of a panel box. The employee fell 8-9 feet from the top of the panel box to the ground. The employee was hospitalized with fractures to their ribs and a shoulder injury.

An employee's hand was caught in a pinch point in the area of a conveyor for a flask running out of a foundry molding machine. The employee's ring finger was crushed and partially amputated at the base.

An employee noticed a block was out of place under the weighted mold frame. The employee used another block to push the block out and replace it. When the block came out, the frame came down on his right ring and little fingers. The employee sustained a fracture and partial amputation to the ring fingertip.

An employee was using a fork truck to move a tub containing molten iron that had been drained from the cupula. The tub tipped over and the molten metal came in contact with water. This caused the molten iron to splash back and burn the employee's upper torso.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.