Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Champion Home Builders, Inc., 1915 SE State Road 100, LAKE CITY, FLORIDA 32025
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was cutting a shim on the quarter-inch flat stock of the table saw when the saw became jammed. While he was attempting to unjam the saw, his right index finger was amputated at the first knuckle, his middle finger was amputated at the second knuckle, and his ring finger was lacerated.
At 7:30 a.m. on March 11, 2025, an employee was cutting angle iron pieces with a saw. When he went to stop the blade, it lacerated his right middle finger.
The injured employee was holding the rafters at the roof build table area while a co-worker attached them to the roof frame using a pneumatic nailer. A four-inch nail ricocheted and pierced the employee's left shoulder resulting in injury to an artery and the left lung.
An employee was using a miter saw to install molding during construction of a new mobile home and sustained severe lacerations to their right arm and hand.
An employee was standing on an A-frame ladder 3 to 4 feet above the ground, replacing the exterior siding of a home. The ladder tilted to one side, causing him to fall off. He suffered eight broken ribs and a collapsed lung.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321991)
On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.
An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.
An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.
An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.
An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.