Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Beacon Roofing Supply, 10000 J St., OMAHA, NEBRASKA 68134
on — Amputations, affecting the fingertip(s).
Final narrative
An employee attempted to catch a bundle of shingles that was about to fall off the truck's conveyor. When he did this, he lost his balance placing his hand in a pinch point and amputating a portion of his right thumb.
An employee was loading bundles of shingles onto a two-story home when he lost his footing and fell to the lower surface. He suffered back and knee injuries.
An employee was delivering shingles to a customer on the roof of a house. The employee fell from the roof edge, landing on the ground 12 feet below and suffering injuries to the nose and cervical vertebrae.
An employee finished unloading building supplies on the roof and was descending the ladder. The employee fell from the ladder and broke bones in the left leg.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 423330)
Employees were at the trucks to leave for lunch. The injured employee was putting the cone back after the crew leader pulled the truck forward from the designated worker parking area. The injured employee then ran back to the truck. As he went to get in the truck, he said the upper thigh area of his leg was hurting. He laid on the ground outside the truck and crew leader could see a bump/bulge in the the injured employee's upper thigh area below his hip. The employee sustained a fractured femur and required surgery.
An employee was helping a contractor unload a delivery of two new dock plates from a trailer onto a forklift. The employee s left index and middle fingers were pinched by the dock plates, resulting in amputations to both fingers above the first joint.
An employee was helping to load a customer's truck. The employee stepped toward a forklift to get paperwork from the driver. The employee's right lower leg and foot were run over by the back tire of the forklift. The employee was hospitalized with fractures to his lower right leg.
An employee was moving wet bundles of shingles on a truck bed, when one of the bundles slipped out of his hands. He tripped over a pallet, fell off the bed of the truck, and landed on his left side. The employee sustained fractures to three ribs, and a displaced iliac fracture.
On August 12, 2025, an employee was loading shingles onto the roof of a new-construction home when be began to suffer from heat exhaustion and dehydration.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.