WILLACOOCHEE INDUSTRIAL FABRICS, INC.

An employee was working on a propane-fueled forklift when he suffered flash burns to his face and hair.

While shrink wrapping a roll of fabric on a re-roll machine, both of an employee's hands and arms were pulled into the machine resulting in bruising. The employee was hospitalized.

An employee was bitten by a spider while cleaning a piece of equipment.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was operating an electric standing pallet jack and pulling an empty A-frame when the jack struck a guard rail. The employee fell from the lift to his right hip and elbow on the concrete floor, and was hospitalized with a fractured hip.

An employee was clearing yarn that had wrapped around a gear-driven conveyor belt when his left arm got pulled between the belt and a roller. The employee sustained a fractured arm, as well as lacerations and abrasions.

On November 5, 2024, an employee was working on a lamination line. He had removed a slot assembly from a coating station, placed it into a portable slot cleaning tank, and rolled the cart with the assembly out of the cleaning tank. He hit the door of the coating station, and the slot assembly fell from the cart and crushed his little finger. He suffered an amputation above the first knuckle.

An employee was working on the thermal bond production line when the laydown formation table became filled with fabric. The employee was cleaning the area when the machine restarted. The employee's hands were caught between a belt and a roller resulting in amputations to multiple fingers on both hands.

An employee was correcting a malfunction on a covering machine when their left hand was caught in a moving component and they sustained a left index fingertip amputation.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.