Ignition of vapors, gases, or liquids · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at MIDWEST ENERGY INC., 1330 CANTERBURY DR., HAYS, KANSAS 67601
on — Second degree heat (thermal) burns, affecting the nonclassifiable.
Final narrative
An employee was hot wrapping a pipe using flammable glue and a flame torch. The mixture ignited and the employee suffered second degree burns.
On 4/15/2015, at 11:15 a.m., an employee working on a pad mount transformer came in contact with the 7200V underground cable live wire. The employee sustained a first degree burn on the left hand.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.
An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.
At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.