Printpack, Inc.

A maintenance employee was using a rubber roll grinding lathe to resurface a rubber roller/sleeve. The lathe has a grinding wheel attached to it which passes across the roller to remove a fine layer of rubber from the roller to remove any blemishes that would affect the printing process when it is placed back into a printing press. When the employee went to wipe the rubber dust away from the roller/sleeve their right ring finger contacted the grinding wheel at the end of the lathe. The employee sustained an open fracture of the distal phalanx of the right ring finger resulting in a surgical, partial amputation and a laceration to the little finger with damage to the nail.

On February 16, 2023, an employee was removing a piece of film from a machine when his right thumb was pulled into the nip-point and amputated.

An employee was using a rag and solvent to clean a chrome roller when their right hand was pulled into a nip point created by the drive roller and the chrome roller resulting in contusions and swelling.

A pallet had been loaded onto a trolley to be picked up for wrapping, but a broken bottom board on the pallet was blocking an entry roller sensor, tripping it and preventing the trolley from moving. An employee removed the board and the trolley began to travel. Her left knee and thigh were lodged between the framing of the trolley and a stationary pallet insert line. She suffered a laceration to the back of the thigh.

An employee was moving a manlift onto a freight elevator when it fell onto his left leg resulting in a compound fracture.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was using straps to secure a load inside a transport trailer. The employee was standing on a stack of finished goods that was three pallets high. Each pallet was 16 inches high. He was walking from the stack of three pallets onto a stack of two pallets when he lost his balance and fell onto another stack of finished goods (that was two pallets high) and then landed on the floor of the trailer. The employee was hospitalized with fractured ribs.

An employee was unclogging a resin sifting machine. The rotary sifter's automatic system activated and the sifter blade struck the employee's fingertip, causing an avulsion. The fingertip was medically amputated.

An employee was helping to remove a roll of plastic from a line when the tail stock on the machine snapped back and caught the employee's right middle fingertip, resulting in a partial amputation.

An employee was investigating a possible issue with a piece of equipment when the equipment started and amputated his left index fingertip.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.