Federal OSHA recorded a severe workplace injury
at ACME Energy Services, Inc., 7500 W Hwy 80, MIDLAND, TEXAS 79706
on — Fractures, affecting the back, including spine, spinal cord, unspecified.
Final narrative
Employees were picking up a mud pump using a winch and two trucks. The winch line slipped and broke causing the truck holding the pump to be raised approximately five feet off the ground and then slammed back down. The employee in the truck suffered a compression fracture in their back.
HospitalizedBack, including spine, spinal cord, unspecifiedHighway vehicle, motorized, unspecified
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.