C.M. Mitchell Construction Co., Inc.

An employee was using a shepherd's hook to help position a jib crane. The hook slipped and the employee fell into an adjacent structure, suffering three broken ribs and a punctured lung.

An employee was taking measurements of a parapet cap when they fell to the ground sustaining fractures to a shoulder and arm.

An employee was cleaning a two-story house. They fell approximately 12 feet from the roof to the floor and sustained fractures to both wrists.

An employee was using a water hose to clean the outside of a wastewater drain system when he fell into an area of the drain that was not covered. Hot water and chemicals caused first, second, and third-degree burns all over the employee's body. The employee was hospitalized.

An employee was cutting down a steel above-ground storage tank. He was on the roof of the tank when he fell 20 feet to the ground, resulting in a broken elbow and sprained leg. The employee was wearing a harness that was tied off at the time.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was installing insulation in a wall when she tripped on a hole (12" deep) and fell, hitting her head on the concrete floor. The employee sustained fractures to her leg and wrist, and lacerations to her head. The employee was hospitalized.

An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.

An employee was operating a power drill when it slipped. The drill bit punctured the employee's hand and they were hospitalized.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

An employee was preparing hot melted butter on a flat-top grill and placing it in small containers once it was melted. As she turned to set the container down, it slipped out of her hand and landed on the grill. Butter splashed up and hit her in the face. The employee suffered second-degree burns to her right eye and the right side of her head and face, as well as first-degree burns to her right forearm.

An employee pulled into the customer's driveway, parked, and exited the vehicle. He opened the sliding side door on the vehicle to retrieve a package. The customer began backing their vehicle out of their garage and it struck the employee in the back of his left leg. He was pinned him between the two vehicles, causing contusions and lacerations.

An employee reached into a hamper, picked up a package, and was hospitalized with a back injury that caused pain in his lower extremities.

On July 10, 2025, an employee tripped over a yellow pillar and fell to the floor. The employee was hospitalized with a fractured left femur.