Fall to lower level, unspecified · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Azteca Milling, Lp, 1388 Co Rd U, PLAINVIEW, TEXAS 79072
on — Heat (thermal) burns, unspecified, affecting the whole body.
Final narrative
An employee was using a water hose to clean the outside of a wastewater drain system when he fell into an area of the drain that was not covered. Hot water and chemicals caused first, second, and third-degree burns all over the employee's body. The employee was hospitalized.
At about 2:00 a.m. on March 11, 2022, an employee was collecting a product sample from a macerator unit using an extended bar with a cup at the end. When the employee opened the small compartment of the macerator to collect the sample, the bar became stuck in the auger. The employee's left hand was caught between the bar and the edge of the compartment door. He suffered a radial fracture to the index finger.
An employee was placing screens at a sifter when his left middle finger was caught in the press plate of the sifter resulting in a partial amputation of the fingertip.
An employee was using a shepherd's hook to help position a jib crane. The hook slipped and the employee fell into an adjacent structure, suffering three broken ribs and a punctured lung.
An employee was cutting down a steel above-ground storage tank. He was on the roof of the tank when he fell 20 feet to the ground, resulting in a broken elbow and sprained leg. The employee was wearing a harness that was tied off at the time.
An employee was inspecting the floor to install floor trusses on the second level when they fell approximately 9 feet to the concrete floor below. The employee sustained a right leg fracture.
More severe injuries in this industry (NAICS 311211)
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was checking a flour roll stand for a blockage. The employee's right hand was caught in an ingoing nip point on the machine, causing partial amputations to the thumb and middle, ring, and little fingers.
An employee was climbing an A-frame ladder to adjust an exhaust pipe on the wall to let the heat out. The employee fell 4-5 feet and injured his right tibia and ankle.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.