Diamond Chemicals

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was applying pressure to a tank car loaded with caustic soda solution for post-load leak testing. He twisted the valve plug to check it for leaks when it broke free, releasing the caustic soda solution through the opening. The employee suffered chemical burns to both eyes and to his respiratory tract.

Employees were setting up an 8-inch sewer PVC pipe line. An employee was removing/rolling a scrap PVC pipe off the conveyor when their little fingertip was crushed between the end of the PVC pipe and the post for the overhead bus stop guard (fixed guard). The employee was hospitalized and required surgery.

An employee was walking by an equipment battery (tank battery) when a leak occurred around a heater that caused a flash fire. He was wearing flame-resistant clothing and sustained burns to his palms and back.

Two employees were removing a recirculation pump from service at an evaporator. They were disconnecting pump flanges and couplings from the motor when boiling water burst out from the system. Both employees sustained second-degree burns to the chest, stomach, and arms.

On December 9, 2024, an employee was cleaning out a mixtruder. While he was retrieving some residual pieces of silicone left inside, its rotating blades caught the fingers of his right hand resulting in amputation of all four fingers. The thumb was left intact.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.