Contact with hot objects or substances · Thermal burns second degree
At a glance
Federal OSHA recorded a severe workplace injury
at Ascend Performance Materials, Inc., 3000 Old Chemstrand Rd, CANTONMENT, FLORIDA 32533
on — Thermal burns second degree, affecting the Trunk and other upper extremities.
Final narrative
Two employees were removing a recirculation pump from service at an evaporator. They were disconnecting pump flanges and couplings from the motor when boiling water burst out from the system. Both employees sustained second-degree burns to the chest, stomach, and arms.
Hospitalized Trunk and other upper extremities Water, liquids nonchemical
More severe injuries at Ascend Performance Materials, Inc.
A maintenance employee was removing a level control valve when he was sprayed with Hexamethylenediamine (HMD). The contents of the pipe were under pressure and the liquid was hot, but less than 100 degrees Celsius. The employee sustained chemical burns and possibly thermal burns to his face and back.
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 325110)
An employee was applying pressure to a tank car loaded with caustic soda solution for post-load leak testing. He twisted the valve plug to check it for leaks when it broke free, releasing the caustic soda solution through the opening. The employee suffered chemical burns to both eyes and to his respiratory tract.
Employees were setting up an 8-inch sewer PVC pipe line. An employee was removing/rolling a scrap PVC pipe off the conveyor when their little fingertip was crushed between the end of the PVC pipe and the post for the overhead bus stop guard (fixed guard). The employee was hospitalized and required surgery.
An employee was walking by an equipment battery (tank battery) when a leak occurred around a heater that caused a flash fire. He was wearing flame-resistant clothing and sustained burns to his palms and back.
On December 9, 2024, an employee was cleaning out a mixtruder. While he was retrieving some residual pieces of silicone left inside, its rotating blades caught the fingers of his right hand resulting in amputation of all four fingers. The thumb was left intact.
An employee was removing a brine belt on a unit when they tripped over a 9-inch wall, fell backward approximately 14 inches to a lower level, and landed on their back. The employee sustained a concussion.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.