Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at FAIRVIEW MILLS LLC., 601 S. Mill Street, ANDERSON, MISSOURI 64831
on — Electrical burns, unspecified, affecting the hand(s) and arm(s), unspecified.
Final narrative
An employee was attempting to pull fuses from an energized electrical panel when an arc flash occurred and burned the employee's left arm and hand.
HospitalizedHand(s) and arm(s), unspecifiedSwitchboards, switches, fuses
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 311111)
An employee was working to remove a spatula that got stuck in an auger at the bottom of a hopper. The employee went to remove the face plate to help release the spatula. His fingers were in the holes to pull off the face plate when the machine actuated. His right middle finger got trapped between the face plate and the inner plate, resulting in amputation.
An employee was walking in a parking lot during break when they were struck by a vehicle, resulting in fractures to their left scapula and lower right leg.
An employee bent down to turn on an air valve, lost their footing, and struck their hand on a pressure relief valve while trying to catch themselves. The employee suffered an amputation to their right index fingertip.
An employee was working on a production line, packaging chews for animals. She retrieved a fallen cap for another production line from the floor and went to put in back in the machine it had fallen from (a capper). The machine caught the tip of her left little finger, causing a fingertip amputation.
An employee was taking apart the piping to a meat pump for clean-up. He saw food debris inside the pump housing and went to remove it. The meat pump rotor caught and severed his right index and middle fingertips, resulting in partial fingertip amputations.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.