D & S Machine Service, Inc.

An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.

A ramp in the trunk of a delivery van struck an employee's calf. She suffered a broken leg and was hospitalized.

An employee was completing a service call and looking at a water pump when the pump cover plate struck their forehead. The employee sustained a forehead laceration and fracture requiring hospitalization.

An employee was removing chains from a steel tube. A sorting hook attachment was caught on the staging area cross member. When he raised the chains, the sorting hook snapped back and struck the employee's face causing a fractured jaw.

An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.

An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.

An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.

An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.

An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.

An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.