Adams Construction Co.

An employee was directing traffic when a shag truck turned sharply and ran over the employee. They suffered a crush injury to the lower left leg and internal bleeding.

An employee was standing on the street holding a stop/slow paddle and directing the flow of traffic. As they were holding the stop sign, a vehicle attempted to drive around the employee but struck them. The employee sustained fractures to the tibia and fibula and was hospitalized.

A paving crew was working on a roadway when a motor vehicle entered the work zone. Two employees sustained injuries including fractures and damage to internal organs that required hospitalization.

An employee was flagging traffic when they were struck from behind by a car that entered a work zone. The impact of the vehicle threw the employee approximately 45 feet and she landed on another employee. The employee who was struck by the car sustained a head laceration and fractures to the ribs and ankle.

An employee was setting up a worksite on a roadway when they were struck by a vehicle. The employee suffered blunt force trauma to the chest, pelvis, and legs from contact with the vehicle, with subsequent trauma to the neck and head upon falling to the ground.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.