Caught in running equipment or machinery, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Felderhoff Brothers Drilling, XTO Well-Guycoden Unit 2- 2507BH , MIDLAND, TEXAS 79701
on — Fractures, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was moving a catwalk (a long piece of equipment that helps move tube) against a rig to perform an inspection when his right ring finger was caught and fractured between the catwalk skate and a pin. He was hospitalized.
HospitalizedFinger(s), fingernail(s), unspecifiedOil drilling rigs and machinery
More severe injuries at Felderhoff Brothers Drilling
An employee was removing a pressure relief valve from a mud pump with a 36-inch pipe wrench. The pipe wrench slipped and caught the employee's finger between the wrench and the mud pump resulting in amputation of the left middle finger and a fracture to the ring finger.
An employee was attempting to remove a pin from a derrick when a forklift operator moved the derrick board unexpectedly. The employee's right thumb was then caught and amputated between the pin and the handrail.
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.