Other fall to lower level, unspecified · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at HELMERICH & PAYNE, INC, Rig 396, TULIA, TEXAS 79088
on — Bruises, contusions, affecting the nonclassifiable.
Final narrative
An employee was descending the stairs of a drilling rig to take his break when he slipped and fell, suffering bruising.
HospitalizedNonclassifiableOil drilling rigs and machinery
An employee had been working on mud pumps. While taking a break, the employee became ill and experienced various symptoms of heat-related illness including cramping, dizziness, slurred speech, and shaking.
A crew was installing skid rails. The injured employee was checking the alignment of two sections of skid rails when the pieces moved and his right middle and ring fingers were caught in the pin hole connection of the two sections. Both fingertips were amputated.
An employee was caught between pieces of drilling equipment (ST-80 and mast leg) while making a connection on the rig floor, resulting in a lacerated liver.
An employee was racking drill pipe on the rig floor. As a stand of drill pipe was being set down on the rig floor, the employee slipped and fell. The stand of pipe was set down on his left hand resulting in a partial amputation to the middle finger.
An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.
An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.
An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.