Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at CLEARSPAN COMPONENTS, INC., 6110 OLD HWY 80 W, MERIDIAN, MISSISSIPPI 39301
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was feeding lumber into a header saw when the saw was activated via the foot switch, causing it to cycle and amputate his left ring finger at the nail.
An employee was operating a cap saw when a block of wood became wedged between the saw blade and the conveyor. The employee turned the saw off and was reaching under the saw to remove it when the blade lacerated the employee's hand.
An employee was attaching oriented strand board (OSB) sheathing to exterior wall paneling using a staple bridge machine and was caught in the in-feed chain resulting in partial amputation of the distal part of the right middle finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321918)
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was adjusting the height of an ultraviolet (UV) lamp. She was electrocuted by the UV machine. She sustained burns on her left hand and an entry wound on the right forearm. The employee was hospitalized.
On August 14, 2025, an employee was rebuilding a tile-cutting die when their right wrist contacted the cutting blade, resulting in a laceration that required hospitalization.
An employee was removing a jammed piece of scrap wood from the end of a machine saw when the wood pulled their right hand into the saw blade, resulting in an index finger amputation below the second knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.