Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Clearspan Components, Inc., 6110 Old Highway 80 W, MERIDIAN, MISSISSIPPI 39307
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was attaching oriented strand board (OSB) sheathing to exterior wall paneling using a staple bridge machine and was caught in the in-feed chain resulting in partial amputation of the distal part of the right middle finger.
AmputationFinger(s), fingernail(s), unspecifiedMetal, woodworking, and special material machinery, n.e.c.
More severe injuries at Clearspan Components, Inc.
An employee was operating a cap saw when a block of wood became wedged between the saw blade and the conveyor. The employee turned the saw off and was reaching under the saw to remove it when the blade lacerated the employee's hand.
An employee was feeding lumber into a header saw when the saw was activated via the foot switch, causing it to cycle and amputate his left ring finger at the nail.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321992)
An employee was working on flooring tile, which required several continuous hours of kneeling. The next morning, he noticed fluid and swelling on the right knee. When he knelt to perform work tasks, he felt an immediate sharp, burning pain. The employee was hospitalized with an infection.
An employee was using a circular saw to cut rafters when their hand contacted the blade, resulting in amputations to their left ring and index fingertips.
The injured employee was inside a scissor lift. The scissor lift operator turned the lift to the left and crushed the injured employee's right hand between the wall and the lift. The injured employee sustained a right hand fracture.
An employee was operating a forklift to move material. They slipped on the step while descending from the forklift and fell to the ground, fracturing their tibia. The employee was hospitalized.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.