Baco Enterprises

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was working on a portable stainless-steel vessel equipped with a butterfly valve at the bottom. The employee used a crane to raise the vessel and connected an airline to the valve control. Upon activating the compressed air supply, the valve opened. While holding the bottom of the vessel with their left hand, the airline disconnected and the valve closed on their left index fingertip. The employee sustained an avulsion of the fingernail, an open nondisplaced fracture of the distal phalanx, and partial amputation of the fingertip.

An employee was in training to learn how to change steel dies on a culvert machine. The employee was on top of the machine when the handheld control was activated, engaging the machine's auto-run function. The employee's feet were dragged into the roller dies, resulting in a left ankle fracture, a laceration between the ankle and knee, and amputation of the the big toe and second toe on the right foot.

An employee was walking up the stairs in an office area. Their right foot caught the edge of the stair at the top of the stairwell and they fell forward. The employee sustained a neck fracture.

An employee was operating a clipper machine and contacted maintenance when they noticed the machine was not working properly. Maintenance worked on the machine. While verifying that the machine was fixed, the employee's left index finger was amputated above the first knuckle.

An employee was feeding a strip of steel into a power press when it activated and contacted the injured employee's left hand. The employee suffered amputations of the first two digits of the hand.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.