Contact with hot objects or substances · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Dionisio Metal & Iron, Inc., 700 S. Portland Street, PUEBLO, COLORADO 81001
on — Third or fourth degree heat (thermal) burns, affecting the upper extremities, unspecified.
Final narrative
An employee was loading an aluminum, oil-fired furnace (to make aluminum ingots) when a coworker threw a coil-covered shock into the furnace. The shock ruptured and sprayed hot oil onto the employee, resulting in third degree burns to the upper extremities.
HospitalizedUpper extremities, unspecifiedCoal, natural gas, petroleum fuels and products, unspecified
More severe injuries at Dionisio Metal & Iron, Inc.
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 331491)
An employee was cutting a metal square on a hydraulic shear when his left hand got caught between the metal and the shear block. The employee's middle finger was amputated.
An employee was uncoupling railcars while the cars were in motion and a car ran over her left lower leg, resulting in crush injuries and amputation below the knee. The employee was hospitalized.
An employee was working to remove a piece of wood that was jamming a transfer conveyor at the shredder. He used a tool to clear the jam, then reached to grab the wood. His sleeve got caught in the conveyor and his right arm was pulled into the pulley. The employee was hospitalized with an open fracture and a crush injury/laceration to his right forearm. The machine was running at the time.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.