Entergy Corp.

An employee was getting a tool bag that was on a second-story roof when they fell from the roof to the ground. The employee was hospitalized with injuries to their rib cage and lower back.

An employee was installing a clip on the roof when they slipped and fell approximately 25 feet to the ground below, resulting in a broken hip, broken leg, and bleeding in the brain.

An employee was setting up the worksite for the day. While moving an extension cord, he fell backward off the roof of the two-story building and sustained a broken pelvis.

An employee was going up in a lift to begin trimming trees with a chainsaw. He was approximately 20-25 feet in the air when the latch to the bucket got caught and detached. The bucket then tipped causing the employee to fall to the ground. He sustained fractures to his right elbow, right wrist, and left femur.

An employee was laying down felt paper on a new residential property when they fell approximately 21 feet to the ground. The employee sustained fractures of the L2 vertebra, right tibia, and left wrist as well as a left heel dislocation. The employee was wearing fall protection at the time.

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.