Part of occupant s body caught between vehicle and other object in nonroadway transport incident · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Kolberg Pioneer, 700 W. 21st Street, YANKTON, SOUTH DAKOTA 57078
on — Crushing injuries, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a forklift to move a rolling cart with a spiral weldment. As he was pushing the spiral and cart, the forklift entered an inclined area. The front of the cart and the spiral started drifting/rolling down the incline. He put the forklift in reverse and backed up to get in front of the spiral and cart as it was rolling and then reached out with his right hand to deflect the cart's direction of travel. His right finger middle finger was then caught and crushed between the spiral and the roll cage of the forklift.
HospitalizedFinger(s), fingernail(s), n.e.c.Forklift, order picker, platform truck-powered
An employee was training on an rolling container carrier on the dry, non-frozen storage side of the distribution center. She made a turn around the end cap and her right foot struck the rail protecting the endcap racking. The employee's foot was fractured.
An employee was a passenger in a utility vehicle that was driving up a hill on a wooded trail. As the vehicle made a right turn, three fingers on the employee's right hand were caught against a tree and fractured.
An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.
The injured employee was assisting with tightening down 3/4" hardware during assembly of a 6'x20' triple deck screen. Another employee was using a 1/2" cordless impact wrench to tighten down the hardware. The injured employee was using a 1-1/8" open-end wrench that slipped when the bolt was being tighten down by the impact wrench. The injured employee's right ring fingertip was caught between the open-end wrench and the side sheet of the triple deck screen. The tuft of the distal phalanx was amputated.
An employee was welding baffle plates onto a 55-gallon hydraulic tank. A flash occurred as they began to tack weld a part. The employee suffered burns to most of their face and second-degree burns on each arm, resulting in hospitalization.
On July 22, 2024, an employee was using a pressure washer to fill a mop bucket with water. The washer's hose split and soapy water was injected into the employee's right palm and index finger. The puncture wound had to be surgically cleaned.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.