Injured by handheld object or equipment, unspecified · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at TD Industries, 1400 S Sherman St , RICHARDSON, TEXAS 75081
on — Cuts, lacerations, affecting the wrist(s).
Final narrative
An employee was working on a 16-inch stainless steel duct work. He was putting a coupling inside the duct and lacerated his wrist above his glove.
Employees went to a site for a water leak and had to remove the floor access hatch. While doing so, the door came off its hinge. They were attempting to reposition the hatch when the injured employee placed his fingers under the hatch to move it. The hatch then shifted on the broken hinge and dropped on his finger, resulting in the partial amputation of his left middle fingertip (no bone loss).
An employee was operating a pipe grooving machine to groove a steel pipe when his glove became caught and his hand was pulled in between the pipe and the back plate of the machine. His left middle, ring, and index fingers were partially amputated.
An employee was climbing a fixed ladder to the roof and fell. The employee sustained a fractured left ankle and leg requiring hospitalization and surgery.
An employee was tailing logs with a chainsaw. As they set the chainsaw on a log, the chain contacted the employee's left index finger, fracturing it. The fingertip was surgically amputated.
An employee was using a Johnson bar to pry a piece of concrete with the help of a skid steer. When the bar moved, the employee was struck in the mouth by it, resulting in a tooth avulsion and a mouth injury that required stitches.
An employee was helping another employee pick up a round piece of metal to recoup a skid. The metal slipped and lacerated the employee's right middle finger, resulting in a fingertip amputation.
An employee was attaching a wrench to a drill rig rod. The wrench turned and struck the employee's right hand, resulting in a laceration and fracture to their index finger.
An employee was climbing a ladder while carrying 12-foot metal trims to the roof. As the top end of the metal rose above the parapet wall of the roof, a strong gust of wind spun the metal backward, causing the employee to lose his grip on the metal. The trims lacerated his left wrist, which required hospitalization and surgery.
More severe injuries in this industry (NAICS 238220)
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was trimming out sprinklers on the exterior of a building when he fell off an extension ladder. He landed on the ground and sustained fractures to his nose and arm.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.