TMCo, Inc

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was repositioning a large casting with a chain. The chain slipped and landed on his hand, resulting in hospitalization with a fracture to his upper arm and a crushing injury to his thumb.

An employee was performing a machine set-up and had installed one set of holding jaws. His right index finger became caught in an air vise while re-clamping a part. The employee sustained a partial amputation above the fingernail.

Two employees were re-packing a butterfly valve. The valve was being held by a crane. An employee added air to the valve to close it. The valve moved and the other employee reached to steady it. His thumb was caught in the valve and the thumb tip was amputated.

An employee was preparing to install a production tree/master valve. The employee grabbed the bull plug and shook the production tree into place. The well blew out on the casing side. The pressure caused the production tree to fall over onto the employee, resulting in a fractured right leg.

An employee was manually moving a 30-pound valve. When he sat the valve down, it crushed his left index fingertip just above the nail and amputated it.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.