105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Cianbro

Struck by object or equipment dropped by injured worker · Amputations

Federal OSHA recorded a severe workplace injury at Cianbro, 19 Bridge Street, KITTERY, MAINE 03904 on — Amputations, affecting the fingertip(s).

An employee was using a 3-foot pry bar to lift a 3/8-inch piece of sheet of metal to remove the 3/4-inch wooden support blocks from underneath. The 3-foot pry bar slipped while the employee was removing the 3/4-inch wooden block, allowing the sheet metal to drop onto and amputate the employee's left index fingertip.

Amputation Fingertip(s) Sheet metal

Cianbro

An employee was attempting to dislodge a stuck pin in a sheet shackle when the pin engaged after being struck and caught the employee's fingertip, resulting in a fingertip amputation (no bone loss).

View Cianbro's full OSHA safety record →

Southern Metal Processing Company, Inc.

An employee was trying to move a pressure vessel when it fell over. A stud on the top of the vessel struck and gouged the employee's stomach.

Alro Steel Corporation

An employee was standing a steel bar on its edge when the bar fell onto his left hand, resulting in a middle fingertip amputation.

Olive Garden Holdings, LLC

An employee was unloading the dishwasher and dropped a glass, resulting in a left hand laceration that required hospitalization.

Amys Kitchen Inc

An employee was removing a jam from a blancher. As he went to remove the blade, he dropped it, lacerating his leg.

Downs Racing, L.P.

An employee was mounting a TV when they dropped it. The employee suffered a partial amputation of the left index finger.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Takkion OPS Management

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Ahtna Marine and Construction Company, LLC

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

Michels Construction, Inc

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

Bechtel Energy Construction Services, Inc.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

GERRITY INDUSTRIES

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

O&P Glass

An employee was using a metal shear when it amputated the tip of his right index finger.

Cives Steel Company New England

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

Longroad Energy

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.