Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Arconic, 71 Progress Avenue, CRANBERRY TOWNSHIP, PENNSYLVANIA 16066
on — Amputations, affecting the fingertip(s).
Final narrative
On July 8, 2017, an employee was adjusting a part onto a CNC machine. He used a foot pedal to actuate an air clamp to hold the part in place. His left middle finger was caught between the part and the clamp, amputating his fingertip.
AmputationFingertip(s)Special process machinery, n.e.c.
An employee was servicing a pneumatic pump. After he attached an air hose, the air control valve caught his right middle finger, causing a partial tip amputation with no bone loss.
An employee tried to reconnect an airline hose to a tilt table after using the hose to clean a piece of equipment. The table had been switched on, and it began to move to a vertical position while the employee was leaning under it to connect the hose. The employee was pinned between the table support beam and the front edge of the table. The employee suffered broken vertebrae in the back and was hospitalized.
An employee was assisting in a saw re-build. The employee tried to grab a ball screw as it was falling and his finger was crushed/pinched between the falling part and the machinery housing.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332321)
On October 14, 2025, an employee was cutting lumber on an upcut saw. When he activated the saw to cut a short piece, the blade struck the tip of his right thumb, resulting in a partial amputation.
An employee was using a table saw to cut strips of plywood. The employee's left hand came into contact with the sawblade, which amputated the index and middle fingers as well as lacerating the hand. The employee was hospitalized, requiring surgery.
An employee was loading four sliding glass door panels into a truck. He was turning to get a cargo strap when the panels fell onto him and broke his neck.
An employee was using a table saw to cut a small bundle of vinyl material. The saw blade lacerated the employee's left index finger. The employee was hospitalized.
An employee had finished installing hurricane shutters on a customer's home and was putting his tools away and changing clothes. His hands began to cramp; he got out of his truck and collapsed on the road. He suffered an acute kidney injury and rhabdomyolysis caused by dehydration and heat illness.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.