Arconic

An employee's hand was caught between a hoist lifting crane device and a frame that was being hoisted causing a partial amputation.

An employee was servicing a pneumatic pump. After he attached an air hose, the air control valve caught his right middle finger, causing a partial tip amputation with no bone loss.

An employee tried to reconnect an airline hose to a tilt table after using the hose to clean a piece of equipment. The table had been switched on, and it began to move to a vertical position while the employee was leaning under it to connect the hose. The employee was pinned between the table support beam and the front edge of the table. The employee suffered broken vertebrae in the back and was hospitalized.

On July 8, 2017, an employee was adjusting a part onto a CNC machine. He used a foot pedal to actuate an air clamp to hold the part in place. His left middle finger was caught between the part and the clamp, amputating his fingertip.

An employee was assisting in a saw re-build. The employee tried to grab a ball screw as it was falling and his finger was crushed/pinched between the falling part and the machinery housing.

An employee was on a two-step ladder performing cleaning activities in the de-oiler machine. The employee fell back and his right arm was caught in the equipment, resulting in a right forearm fracture that required surgery.

An employee was changing an insert in the tool head of a CNC machine. The employee had stepped up approximately 28 inches onto the door track of the machine. When the employee went to step back down to the floor, they lost balance and fell backward onto a rack of metal parts. The employee sustained a compression fracture to the spine.

An employee was packaging steel coils on a turntable. As he walked across the turntable, he slipped and fell onto a coil. His left bicep was lacerated by the slit edge of a coil.

An employee was monitoring a lumber-stacking machine when they slipped and fell into an unbanded bundle of lumber. The outer row of lumber then fell on their left leg, fracturing their leg and ankle.

An employee was putting parts away in a warehouse. He tripped and fell into metal shelving, resulting in a broken arm.

An employee's left arm was caught in the fingers or jaws of the head stretcher machine, resulting in a laceration. The employee was hospitalized.

An employee was performing regular duties in the cast house and sustained heat exhaustion.

At 7:01 p.m. on June 16, 2025, two employees were pushing a saw horse with a bundle of aluminum on it when it flipped over onto the injured employee. The employee was hospitalized with a broken leg and required surgery.

On June 4, 2025, at approximately 1:00 AM, an employee was working when they experienced cramping and were hospitalized with a heat illness.

An employee was performing maintenance on a press puller and aligning the puller when it fell. The puller electrical panel struck their left upper back, resulting in fractures to their T12 and L1 vertebrae. The employee was hospitalized.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.