Puget Sound Naval Shipyard

An employee was opening a scuttle on the third deck of an aircraft carrier. The scuttle quickly opened and pinched the employee's finger against a scaffold, resulting in a finger laceration and fractures.

An employee was walking toward a stack of wood to remove a tag for material tracking. He slipped on ice and fell, suffering broken ribs.

An employee was working near a drive shaft on a naval vessel. He ducked under the propulsion shaft and his hard hat struck the shaft causing a broken vertebra in his neck. He was hospitalized.

An employee was walking when he tripped over the tines of a parked forklift and broke his right femur, requiring hospitalization and surgery.

An employee was using a pocket knife to cut open a large sack when the sack slipped and the knife amputated his fingertip.

The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.

On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.

An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.

Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.

An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.