Caught in running equipment or machinery during regular operation · Avulsions, enucleations
At a glance
Federal OSHA recorded a severe workplace injury
at Elliott Equipment Co., 4427 S 76th Circle, OMAHA, NEBRASKA 68127
on — Avulsions, enucleations, affecting the fingertip(s).
Final narrative
An employee was attempting to remove a piece of cut angle iron from the fixed vice area of a band saw when his right index and middle fingertips were pinched and avulsed in the vice area.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333924)
An employee was using a punch and hammer to remove a pin from the mast of a forklift. The mast was secured by an overhead crane. The mast shifted, and the employee's thumb was pinched between the mast and the punch, resulting in an amputation to the tip of his left thumb.
On September 22, 2025, an employee tripped and fell over a permanent fixture (angle iron) that serves as a parking block in the back of a facility. He suffered a fractured right hip and was hospitalized.
An employee was helping a customer with repairs on their trailer. While lowering the ramp door of the trailer, the customer dropped the door and it contacted the employee's left ring finger, resulting in a fingertip amputation.
An employee was working to lay a part in the vise of the band saw in preparation for cutting. The left vise closed, pinching his fingertips against the part. The employee's middle and ring fingertips were amputated and they sustained a laceration to the index finger requiring stitches.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.