Pryor Chemical Company

Two employees were working on the well head to bleed pressure off a tank so that ethylene glycol could be added. The sight glass on the tank exploded and struck one of the employees in the face, causing a severe facial laceration and requiring surgery.

A projectile from a CO2 compressor valve struck an employee in the face during maintenance.

On November 27, 2023, an employee was emptying a 2-inch product line that transports sodium hydroxide liquid from a rail car to a 275-gallon tote tank. The nozzle came out of the tote and sprayed sodium hydroxide onto the employee's face. The employee was hospitalized with chemical burns to their face, mouth, and neck.

An employee was working with sulfuric acid as part of the production process. While transferring the chemical from a large container to a smaller container, it splashed on his body and hand, resulting in a chemical burn.

An employee knelt in wet concrete while performing work as a concrete finisher and sustained a chemical burn to the right shin. The employee was hospitalized and required surgery.

An employee was using a 5-gallon bucket to unload acid product from a tank. Residual product leaked into the containment area, causing the employee to sustain first- and second-degree burns to the chest, as well as third-degree burns to the arms.

An employee was transferring an alkaline cleaning chemical from a bulk container into 1-gallon containers. The employee lifted a gallon container by its label tag. The tag broke causing the container to fall approximately 14-18 inches. The container struck the ground and the contents splashed onto the employee causing chemical burns to their eyes.

Two employees were lifting a roll of steel poly bar (50 inches and approximately 150 pounds) from ground level to a height of 4 feet at the 66-inch rubber calendar. One employee dropped the roll, resulting in the poly bar contacting the injured employee's right knee. The employee was hospitalized with fractured right patella.

Employees were loading a 295-pound transformer onto a pickup truck using a forklift. The injured employee was acting as the spotter. The transformer hit the tailgate of the pickup truck and the spotter's right hand was struck by the transformer, resulting in amputation of the ring fingertip.

An employee was wearing full PPE while emptying a 55-gallon drum of phosphorus pentoxide and fainted, collapsing and striking their head against the ground. The employee was hospitalized and it is likely that heat caused by wearing full body PPE contributed to fainting.

An employee was troubleshooting a plug in the super-absorbent polymer line. The employee opened an inspection port and their right hand was caught in a rotary valve, resulting in the amputation of four fingers between the knuckle and the first joint.

An employee was conducting a quality control measure by taking a chemical sample for lab analysis. When the employee was opening the sample point, it broke off and crude 2-Ethylhexyl thioglycolate (EHTG) shot out at 265 degrees, and it covered the employee's legs and right arm and splashed the right side of their face. The employee was hospitalized with first- and second-degree burns to their right thigh, lower right knee, inner left thigh, and upper left forearm.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.