105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Jay Bee Oil and Gas, Inc.

Ignition of vapors, gases, or liquids · Third or fourth degree heat (thermal) burns

Federal OSHA recorded a severe workplace injury at Jay Bee Oil and Gas, Inc., Doc Well Pad, ALMA, WEST VIRGINIA 26320 on — Third or fourth degree heat (thermal) burns, affecting the multiple body parts, n.e.c..

On September 16, 2017, at approximately 11:00 a.m., an employee and two vendor employees were repairing a tank dike liner with a heating iron. Flammable condensate leaked from the plumbing at a hammer union on ground level going to the condensate tank. The heat gun ignited the vapors resulting in third degree burns to the injured workers' hands and face. One employee was hospitalized.

Hospitalized Multiple body parts, n.e.c. Chemicals and chemical products, unspecified

Jay-Bee Oil and Gas, Inc.

On August 3, 2017, at approximately 9:00 a.m., an employee was tending a well while standing between two gas production units approximately 15 feet from a sand separator. At that time, a threaded pipe that was going into the top of the sand separator blew apart. The pipe separated at a 90 degree elbow and released approximately 2,300 lbs. of pressure. The gas from the line projected down towards the ground and the employee's skin was struck by ground debris. He was hospitalized.

View Jay Bee Oil and Gas, Inc.'s full OSHA safety record →

Sam Galloway Ford, Inc.

An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.

Canfor Southern Pine, Inc.

An employee was welding on a rack when sparks ignited residual diesel on his pants. The employee sustained first-, second-, and third-degree burns.

Freedom Trailers, LLC

An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.

Flora-Bama Management, LLC

An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.

JANUS INTERNATIONAL GROUP, LLC

An employee was using a torch when a hole in the oxygen line leaked gas that then ignited. The employee sustained burns to the left palm and wrist.

Hall Drilling, LLC

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

C. Miller Drilling Inc

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

Amercian Well Service Llp

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

Axis Energy Services

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

ROBINSON DRILLING OF TEXAS, LTD

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

Caperton Furniture Works, LLC

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

Certainteed Gypsum West Virginia, Inc

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

Owens Corning

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

Applied Integrated Services, LLC

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

Fedex Freight Inc.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.